1- Dowell, E. H., 1983, The behavior of a linear, damped modal system with a non-linear spring-mass-dry friction damper system attached, Journal of Sound and Vibration, 89, 1, 65-84.
2- Zahrai, S.M., 2010, Passive control of vibrations, the University of Tehran Press, Tehran, Iran (in Persian).
3- Andriono, T., and Carr, A.G., 1991, Reduction and distribution of lateral sesamc inertia forces on base-isolated multistory structures, Bull., NZ Nat. Soc. Earthquake Engineering., 24, 3, 225-237.
4-Pall, A. S., and Marsh, C., 1982, Response of Fiction Damped Braced Frame, ASCE, Journal of Structural Division, 108, 1313-1323.
5- Pall, A. S., and Pall, R., 1989, Friction-Dampers Used for Seismic Control of New and Existing Building in Canada, ATC-17-1, Proceeding of a Seminar and Workshop on Base Isolation and Passive Energy Dissipation, Applied Technology Council, 1989, 675-686.
6- Kelly, T. E., 2001, In Structure Damping and Energy Dissipation, S. E. Holmes Consulting Group, Revision O, July 2001.
7- Zhou, Q., Søren, R.K, and Qu, W. L., 2006, Semi-active control of three-dimensional vibrations of an inclined sag cable with magnetorheological dampers, Journal of sound and vibration, 296, 1, 1-22.
8- Skinner, I. R., Robinson, W. H., and McVerry, G. H., 1993, A book on ‘An Introduction to Seismic Isolation, John Wiley & Sons.
9- Uniform Building Code (UBC), 1997, Earthquake regulations for seismic isolated structures, Whitter CA, USA.
10- Dusi, A., and Mezzi, M., 2007, Increasing Safety of Structures in Seismic Area: The Base Isolation Challenge, Proceedings of the 5th International Conference on Seismology and Earthquake Engineering, International Institute of Earthquake Engineering and Seismology (IIEES), Tehran, Iran.
11- Kilar, V., and Koren, D., 2009, Seismic behaviour of asymmetric base isolated structures with various distributions of isolators, Engineering Structures, 31, 910-921.
12-Vader, A. S., 2004, The influence of signature tower passive energy dissipating devices on seismic response of long span cable-supported bridges, Ph.D thesis, Washington state university.
13- Chachapara, V., Purohit, S., and Patel, P. V., 2011, Seismic Response Control of the buiding using passive devices, Institute of technology, Nirma University.
14- Lee, D.G., Hong, S., and Kim, J., 2002, Efficient seismic analysis of building structures with added viscoelastic dampers, Engineering Structures, 24, 1217–1227.
15- Semih, S. T., and Ozan, U., 2003, Reduction of earthquake response of plane frame buildings by Viscoelastic dampers, Engineering Structures, 25, 1755–1761.
16- Min, K.W., Kim, J., and Lee, S. H., 2004, Vibration tests of 5-storey steel frame with viscoelastic dampers, Engineering Structures, 26, 831–839.
17- Xu, Z. D., Zhao, H. T., and Li, A. Q., 2004, Optimal analysis and experimental study on structures with Viscoelastic dampers, Journal of Sound and Vibration, 273, 607–618.
19- Lewandowski, R., and Łasecka-Plura, M., 2016,
Design sensitivity analysis of structures with viscoelastic dampers,
Computers & Structures, 164, 95-107.
20- Burlon, A., Failla, G., and Arena, G., 2016,
Exact frequency response analysis of axially loaded beams with viscoelastic dampers,
International Journal of Mechanical Sciences, 115–116, 370-384.
21- Lewandowski, R., and Pawlak, Z., 2018,
Response spectrum method for building structures with viscoelastic dampers described by fractional derivatives,
Engineering Structures, 171, 1017-1026.
22- Chang, C. M., Shia, S., and Lai, Y. A., 2018,
Seismic design of passive tuned mass damper parameters using active control algorithm,
Journal of Sound and Vibration, 426, 150-165.
24- Zhang, L., Su, M., Zhang, C., Shen, H., and Zhang, R., 2019,
A design method of viscoelastic damper parameters based on the elastic-plastic response reduction curve,
Soil Dynamics and Earthquake Engineering, 149-163.
25-Robinson, W. H., and Tucker, A. G., 1997, A Lead-Rubber Shear Damper, Bulletin of the New Zealand National Society for Earthquake Engineering, 10, 3, 151-153.
26- Blakeley, R. W. G., 1982, Code requirements for base isolated structures, Proc., Inter. Conf. on Natural Rubber for Earthquake Protection of Bldgs. and Vibration Isolation, 292–311, Kuala Lumpur, Malaysia.
27- Estiri, H., 2012, The Effect of Lead Rubber Separators on Steel Buildings with Converged Brackets, 6th National Congress of Civil Engineering, Semnan University, Semnan, Iran, 2012 (In Persian).
28- Kalantari, S. M., 2008, Investigating the Effect of Seismic Separators on the Class Displacement and Formation of Plastic Joints, Journal of Modeling in Engineering, 6, 15.
29- Torabi, S., 2012, Effect of Lead Rubber Separators on Steel Buildings with Divergent Brackets, 6th National Congress of Civil Engineering, Semnan University, Semnan, Iran (In Persian).
30- Narouei, S., 2014, Effect of Lead Rubber Base Separator on the Performance Level of Coaxial Structured Structures Using Push Analysis, Third National Conference on Industry and Construction, Mashhad, Iran. (In Persian).
31- Shinozuka, M., Chaudhuri, S. R., and Mishra, S. K., 2015,
Shape-Memory-Alloy supplemented Lead Rubber Bearing (SMA-LRB) for seismic isolation,
Probabilistic Engineering Mechanics, 41, 34-45.
32- Hu, K., Zhou, Y., Jiang, L., Chen, P., and Qu, G., 2017,
A mechanical tension-resistant device for lead rubber bearings,
Engineering Structures, 152, 1, 238-250.
33- Zeynali, K., Saeed Monir, H., Mirzai, N. M., and Wan Hu, J., 2018,
Experimental and numerical investigation of lead-rubber dampers in chevron concentrically braced frames,
Archives of Civil and Mechanical Engineering, 18, 1, 162-178.
34- Shoaei, P., and Mahsuli, M., 2019,
Reliability-based design of steel moment frame structures isolated by lead-rubber bearing systems,
Structures, 20, 765-778.
35- Kim, J. H., Kyu Kim, M., Choi, I. K., 2019,
Experimental study on seismic behavior of lead-rubber bearing considering bi-directional horizontal input motions,
Engineering Structures, 198, Article 109529.
36- Eem, S., and Hahm, D., 2019,
Large strain nonlinear model of lead rubber bearings for beyond design basis earthquakes,
Nuclear Engineering and Technology, 51, 2, 600-606.
37- کمیته دائمی بازنگری آییننامه، 1394، آییننامه طراحی ساختمانها در برابر زلزله، استاندارد 2800-ویرایش چهارم، نشریه شماره 253 مرکز تحقیقات راه، مسکن و شهرسازی.
38- Chang, K. C., Lin, Y. Y., and Lai, M. L., 1998, Seismic Analysis and Design of Structures with Viscoelastic Dampers, ISET Journal of Earthquake Technology, 4, 35, 166-143.
39-Win, A. C., 2008, Analysis and Design of Base Isolation for Multi-Storied Building, GMSARN International Conference on Sustainable Development: Issues and Prospects for the GMS, 2008.
40- FEMA356, 2014, The Federal Emergency Management Agency.
41- FEMA451, 2014, NEHRPH Recommended Provisions, Chapter 11: Seismically Isolated Structures. Charles A. Kircher.
)